### Requested by OrcaSlicer
# https://github.com/SoftFever/Orcaslicer/README.md

# Enable object exclusion
[exclude_object]

# Enable arcs support
[gcode_arcs]
resolution: 1

### END

[respond]

[gcode_macro G29]
gcode:
   G28
   BED_MESH_CALIBRATE
   G0 X0 Y0 Z10 F6000
   BED_MESH_PROFILE save=default
   SAVE_CONFIG

[gcode_macro START_PRINT]
gcode:
    {% set BED_TEMP = params.BED_TEMP|default(60)|float %}
    {% set EXTRUDER_TEMP = params.EXTRUDER_TEMP|default(205)|float %}

    # Load previously saved bed mesh
    BED_MESH_PROFILE LOAD=default
    
    # Start bed heating
    M140 S{BED_TEMP}
    # Use absolute coordinates
    G90
    M220 S100 ;Reset Feedrate
    M221 S100 ;Reset Flowrate
    G92 E0 ;Reset Extruder
    # Reset the G-Code Z offset (adjust Z offset if needed)
    SET_GCODE_OFFSET Z=0
    # Home the printer
    G28
    # Move the nozzle near the bed
    G1 Z5 F3000
    # Move the nozzle very close to the bed
    ##G1 Z0.15 F300
    # Wait for bed to reach temperature
    M190 S{BED_TEMP}
    # KAMP - move printhead near print area
    SMART_PARK
    # Set and wait for nozzle to reach temperature
    M109 S{EXTRUDER_TEMP}

[gcode_macro END_PRINT]
gcode:
    # Turn off bed, extruder, and fan
    M140 S0
    M104 S0
    M106 S0
    # Move nozzle away from print while retracting
    G91
    G1 X-2 Y-2 E-3 F300
    # Raise nozzle by 10mm
    G1 Z10 F3000
    G90
    # Disable steppers
    M84

[gcode_macro PRIME_NOZZLE]
gcode:
    G90 ; use absolute coordinates
    M83 ; extruder relative mode
    M220 S100 ;Reset Feedrate
    M221 S100 ;Reset Flowrate
    G92 E0 ;Reset Extruder

    G1 Z10 F240
    G1 X10 Y10 F3000
    G1 Z0.28 F240
    G92 E0
    G1 Y140 E10 F1500 ; prime the nozzle
    G1 X10.6 F5000
    G92 E0
    G1 Y10 E10 F1200 ; prime the nozzle
    G92 E0